* Socket wrench set
* Torque wrench
* Feeler gauge
* Timing light
1. Remove the seat and the left side cover of the ATV.
2. Locate the two timing holes on the left side of the engine block.
3. Insert the timing light into the upper timing hole and point it at the crankshaft pulley.
4. Start the engine and let it run at idle.
5. Use the socket wrench to loosen the bolts holding the ignition coil in place.
6. Rotate the ignition coil until the timing mark on the crankshaft pulley aligns with the timing mark on the stator.
7. Tighten the bolts holding the ignition coil in place.
8. Turn off the engine and remove the timing light.
9. Replace the left side cover and the seat.
