The crank position sensor on the 2003 Hyundai Accent is located behind the timing belt cover, near the crankshaft. It is a small, black sensor with two wires attached to it.
Here are the steps to remove and replace the crank position sensor on the 2003 Hyundai Accent:
1. Remove the serpentine belt.
2. Remove the timing belt cover.
3. Locate the crank position sensor.
4. Disconnect the electrical connector from the sensor.
5. Remove the two bolts that hold the sensor in place.
6. Remove the sensor from the engine block.
7. Install the new sensor in the reverse order of removal.
8. Tighten the two bolts that hold the sensor in place.
9. Connect the electrical connector to the sensor.
10. Install the timing belt cover.
11. Install the serpentine belt.
Note: The crank position sensor is a critical component of the engine management system. If it is not working properly, the engine will not run. If you experience any problems with engine performance, it is important to have the crank position sensor checked.
