* 5/16-inch socket wrench
* 3/8-inch socket wrench
* 1/2-inch socket wrench
* Phillips head screwdriver
* Flat head screwdriver
* Hammer
1. Disconnect the battery. This is important to prevent any electrical shorts from occurring while you are working on the seat.
2. Remove the seat belt. There are two bolts holding the seat belt in place. Remove these bolts and then remove the seat belt.
3. Remove the four bolts that hold the seat to the floor. These bolts are located at the front and rear of the seat.
4. Remove the two screws that hold the seat back in place. These screws are located on the sides of the seat back.
5. Once the screws are removed, you can lift the seat back off of the seat cushion.
6. Remove the front seat cushion by sliding it forward until it comes off of the runners.
7. Remove the rear seat cushion by lifting it up and off of the runners.
1. Slide the front seat cushion onto the runners. Make sure that the front seat cushion is fully seated on the runners.
2. Lift the rear seat cushion up and onto the runners. Make sure that the rear seat cushion is fully seated on the runners.
3. Replace the two screws that hold the seat back in place. Tighten the screws until they are snug.
4. Replace the four bolts that hold the seat to the floor. Tighten the bolts until they are snug.
5. Replace the seat belt. Insert the seat belt through the slot in the seat and then reinstall the two bolts.
6. Reconnect the battery.
Your seat is now installed. Test the seat to make sure that it is secure and that all of the adjustments work properly.
