* Serpentine belt
* Wrench
* Socket set
* Ratchet
* Pliers
Instructions:
1) Park your car on a flat surface and turn off the engine.
2) Open the hood of your car.
3) Locate the serpentine belt. It is the long, thin belt that runs around the front of the engine.
4) Loosen the tensioner pulley bolt with the wrench. This will release the tension on the serpentine belt.
5) Remove the serpentine belt from the engine by sliding it off of the pulleys.
6) Take the new serpentine belt and slide it onto the pulleys in the same way as the old belt was installed.
7) Tighten the tensioner pulley bolt until the belt is snug.
8) Start the engine and check to make sure the serpentine belt is running properly.
9) Close the hood of your car.
Note: If you are not comfortable performing this task, you can take your car to a mechanic to have the serpentine belt installed.
