* Socket wrench set
* Phillips head screwdriver
* Flathead screwdriver
* Wire stripper
* Pliers
Instructions:
1. Disconnect the battery. This is to prevent any electrical shock while working on the voltage regulator.
2. Locate the voltage regulator. On the 1971 Chevelle, the voltage regulator is located on the driver's side inner fender well.
3. Remove the two bolts that hold the voltage regulator in place.
4. Disconnect the electrical connectors from the voltage regulator. There are two connectors: one with a single wire and one with two wires.
5. Remove the old voltage regulator.
6. Install the new voltage regulator. Make sure that the new regulator is properly seated before tightening the bolts.
7. Reconnect the electrical connectors to the voltage regulator.
8. Reinstall the two bolts that hold the voltage regulator in place.
9. Reconnect the battery.
Testing the Voltage Regulator:
1. Start the engine.
2. Check the voltage at the battery. The voltage should be between 13.8 and 14.4 volts.
3. If the voltage is not within the specified range, adjust the voltage regulator. The voltage regulator has a screw on the top that can be turned to adjust the voltage. Turn the screw clockwise to increase the voltage and counterclockwise to decrease the voltage.
Tips:
* When disconnecting the electrical connectors, be careful not to damage the wires.
* If you have a multimeter, you can check the voltage at the battery and at the voltage regulator to make sure that the regulator is working properly.
* If you have any questions about installing the voltage regulator, consult a qualified mechanic.
