Auto >> AutoSPT >  >> Electric car

What is the correct way to add transmission fluid on a 99 Acura TL 3.2 with car off or and what type should be used?

To add transmission fluid to a 1999 Acura TL 3.2, follow these steps:

1. Park your car on a level surface and turn off the engine.

2. Open the hood of your car and locate the transmission fluid dipstick. It is usually located near the back of the engine, on the driver's side.

3. Pull out the dipstick and wipe it clean with a rag.

4. Reinsert the dipstick into the transmission fluid dipstick tube until it is fully seated.

5. Pull out the dipstick again and check the fluid level. The fluid level should be between the "Full" and "Add" marks on the dipstick.

6. If the fluid level is low, add enough transmission fluid to bring the level up to the "Full" mark.

7. Use a funnel to add transmission fluid. Be careful not to overfill the transmission fluid reservoir.

8. Replace the dipstick and close the hood of your car.

The correct type of transmission fluid for a 1999 Acura TL 3.2 is Honda Genuine ATF-Z1.

Auto Repair
What helmets are used in the harley iron 883 commercial? How do you remove front brake drums on a 67 Chevy C10?
Car Care
7 Lessons to Learn About Squeaky Brakes to Avoid Expensive Repairs What to Pack in Your Car’s Emergency Kit Importance of Auto Computer Diagnostics
Engine
What is the red lighting bolt on dash of a Chrysler 300? How do you turn the high beams on and off a 1995 Chevy Corsica?
Electric Car
How do hybrid cars affect the environment? Why would a Chevy Cavalier service light stay on? How do you test the coil pack on a Chevy 4.3L?
Autopilot
How do you make a 99 civic lx faster on first gear? Becoming an Autonomous Vehicle Engineer – Part 1: Beginning the Journey 
Car Photos
What is the towing capacity of 2007 Toyota Camry? Where is the Headlight fuse for a 2002 Jeep Wrangler? What is the significance of cars that come to a screeching stop outside building?