Auto >> AutoSPT >  >> Electric car

Where is the quick connect wiring for electric brake in a 2008 jeep grand cherrokee lorado?

The 2008 Jeep Grand Cherokee Laredo does not have a factory-installed quick connect wiring for an electric brake. You would need to install a wiring harness specifically designed for towing a trailer with electric brakes. The wiring harness will typically connect to the vehicle's electrical system, usually near the battery or fuse box, and provide a connector to which you can attach the electric brake controller. The installation instructions for the wiring harness should provide specific details on where to connect the wires in your vehicle.
Auto Repair
How would you remove and replace a rear passenger door on 1997 Chevy Suburban K1500? What is normal operating temperature for a 2005 dodge neon srt-4?
Car Care
How do you know if it is time to change your air filter? Rickshaw driver need their driving licenses? Are You Ready to Improve Gas Mileage of Your Car?
Engine
Volvo 92 940 location fuel pump relay? What causes idling rpm to go from 700 1500 and back again on a 1991 Jaguar XJS V12 Convertible?
Electric Car
Where is the fuse box on a 2000 Jeep Cherokee? What causes a car battery to drain on mercury sable? How do you get your car out of a parking garage if they closed it for the weekend?
Autopilot
Day 20 Capability : Navigate unexpected lane closures What is the difference between ATV and a motorcycle?
Car Photos
Where can you find the vin plate for a 2005 Volvo tractor truck? Where is the starter on a 2003 Chrysler Town and Country? Is the bolt pattern of a 97 Chevy caprice same as camaro?