Auto >> AutoSPT >  >> Electric car

Which type of motor is not used in axis or spindle drives cnc machine tools?

Stepper motor is not used in axis or spindle drives of CNC machine tools, as those motors only produce full rotations and not continuous circular motion like servomotors and induction motors do.
Auto Repair
How do you change rear brakes on Ford Freestar? How do you replace a 1981 VW Rabbit ignition damaged in theft attempt?
Car Care
Running Your Car in 4WD All the Time? Good or Bad? How To Jump Start A Car Battery The Right Way How safe are Saab automobiles?
Engine
Can your check engine light turn on if oil low? Whats the name of special tool used to take off fuel filter?
Electric Car
Electric Citroen AMI ONE concept revealed Where do you install the water temp sensor on a small block Chevy? How do you install a window lift motor in 2001 Chevy 1500 truck?
Autopilot
Can you adjust your mirrors when parallel park on the driving test NJ? How do you make a 99 civic lx faster on first gear?
Car Photos
How to put back together a 1984 Chevy Celebrity steering column? How do you change high brake light in 1989 Cadillac Brougham? What would make headlights burn out on a 1971 super beetle Volkswagen?