The speed sensor on the 2000 Dodge Stratus Sedan 2.4L is located on the transmission case, near the driver's side front wheel. It is a small, cylindrical sensor with a single electrical connector. The sensor is held in place by a single bolt.
Steps to Remove the Speed Sensor
1. Disconnect the negative battery terminal.
2. Raise the vehicle on a jack and support it on jack stands.
3. Remove the driver's side front wheel.
4. Locate the speed sensor on the transmission case.
5. Disconnect the electrical connector from the sensor.
6. Remove the bolt holding the sensor in place.
7. Remove the sensor from the transmission case.
Installation
To install the speed sensor, simply reverse the removal procedure. Be sure to tighten the bolt securely.
Tips
- When removing the speed sensor, be careful not to drop it. The sensor is fragile and can be easily damaged.
- If the sensor is damaged, it must be replaced. Do not attempt to repair it.
- The speed sensor is a critical component of the vehicle's electronic control module (ECM). If the sensor is malfunctioning, it can cause a variety of problems, including:
- Incorrect speedometer readings
- Transmission shifting problems
- Engine stalling
