- Flat-head screwdriver
- Phillips-head screwdriver
- Replacement power window switch
Instructions:
1. Disconnect the battery. This is a safety precaution to prevent any electrical accidents.
2. Remove the door panel. There are several screws that need to be removed in order to do this. The screws are located around the edges of the door panel.
3. Locate the power window switch. It is usually located on the driver's side door, but it may be located on the passenger's side door as well.
4. Disconnect the electrical connector from the power window switch. There is a small tab that you need to press in order to release the connector.
5. Remove the old power window switch by unscrewing the screws that hold it in place.
6. Install the new power window switch by reversing the steps above.
7. Test the power window switch to make sure it is working properly.
8. Reconnect the battery.
Tips:
- If you are having trouble removing the door panel, you may need to use a pry tool.
- Be careful not to damage the electrical connector when you are disconnecting it.
- Make sure that the new power window switch is properly installed before you test it.
