Auto >> AutoSPT >  >> Electric car

Where is the wire that you unplug to set timing on a 1994 Chevrolet truck?

The ignition control module wire harness disconnect procedure to set the timing is as follows:

1.) Locate the ignition control module under the hood. It is a gray box, bolted down with two 10 mm bolts.

2.) Unplug the electrical connector from the bottom of the ignition control module.

3.) Start the engine and set the timing. It should be set to 0 degrees before top dead center (BTDC) for the 5.0L engine and 6 degrees BTDC for the 5.7L engine.

4.) Stop the engine and plug the ignition control module connector back in.

Auto Repair
How to replace a front wheel bearing on 1997 Mazda Protege? Where cars are repaired?
Car Care
Why Dim Headlights? All Potential Causes and Solutions! Does Honda Pilot have 3rd row seatting? Helping your employees reduce car expenses
Engine
Fuel mixer for 1990 300 Honda trx? Can you bypass a supercharger on 3.8 Liter GM?
Electric Car
Are there any convertible hybrid cars? Where is the fuse box on a 1994 ford econoline van? Where is the aux input jack on a 2004 Chevy Silverado?
Autopilot
What is mission and vision of SKODA Auto? What is the Mercedes Crank Position Sensor?
Car Photos
How does lightining affects person sitting in car? Where is the IAT sensor located 98 Volvo s70 glt? How much is a 2000 BMW worth?