Materials Needed:
- #194 wedge base bulbs
- Small flathead screwdriver
- Replacement bulbs
Instructions:
*1. Preparation:*
- Turn off the engine and allow the vehicle to cool down.
- Locate the AC control panel. In the 1997 Chevy Silverado, it is usually below the radio and above the climate controls.
*2. Remove the Control Panel:*
- Use a small flathead screwdriver or a trim removal tool to gently pry open the AC control panel housing.
- Be careful not to damage the surrounding plastic.
*3. Access the Light Bulbs:*
- Once the control panel housing is open, you will see the AC control light bulbs.
- They are usually small, round, and have a wedge-shaped base (#194 bulbs).
*4. Remove Old Bulbs:*
- Gently twist the old bulbs counterclockwise to remove them from their sockets.
*5. Install New Bulbs:*
- Align the new bulbs with the sockets and gently push them in until they click into place.
- Make sure to install the bulbs in the correct orientation (refer to the old bulbs if necessary).
*6. Test the Lights:*
- Turn on the headlights or the dash lights to test the new bulbs. Make sure they light up properly.
*7. Reattach the Control Panel:*
- Once the bulbs are working, carefully reattach the control panel housing by snapping it back into place.
Note:
If only one of the AC control bulbs is burned out, it is recommended to replace both bulbs for even lighting. After reattaching the control panel, ensure there are no gaps to prevent dust or debris from entering.
The bulb type used in the 97 Chevy Silverado's AC control panel is #194 wedge base bulbs. These bulbs are readily available at automotive stores or online.
