1. Retrieve the DTC (Diagnostic Trouble Code) for the SRS light. You can do this using a scan tool or by following these steps:
* Turn the ignition key to the "ON" position without starting the engine.
* Find the SRS indicator light on the instrument cluster.
* Press and hold the odometer reset button until the SRS light begins to blink.
* Count the number of times the SRS light blinks.
* The DTC for the SRS light will be displayed as a two-digit number.
2. Connect a scan tool to the vehicle's diagnostic port. The diagnostic port is usually located under the dashboard, near the steering column.
3. Turn the ignition key to the "ON" position.
4. Follow the prompts on the scan tool to access the SRS system.
5. Select the "Clear DTC" option.
6. Turn the ignition key to the "OFF" position.
7. Start the engine and check to make sure the SRS light is off.
Method 2: Using a Jumper Wire
Disclaimer: This method is more advanced and carries the risk of causing further damage to your vehicle. It is recommended that only experienced DIY mechanics attempt this method. Follow these steps at your own risk.
1. Disconnect the negative battery terminal. This will help to prevent any electrical damage while you are working on the vehicle.
2. Locate the SRS control unit. It is usually located under the dashboard, near the steering column.
3. Find the SRS connector on the control unit. The SRS connector is usually a white or gray connector with two pins.
4. Connect a jumper wire between the SRS connector pins.
5. Turn the ignition key to the "ON" position.
6. Leave the jumper wire connected for approximately 10 seconds.
7. Turn the ignition key to the "OFF" position.
8. **Remove the jumper wire.
Reconnect the negative battery terminal.**
10. Start the engine and check to make sure the SRS light is off.
