The blower motor resistor is located on the passenger side of the vehicle, behind the glove box. To access the resistor, you will need to remove the glove box.
Here are the steps on how to remove the glove box:
1. Open the glove box.
2. Locate the two Phillips head screws that hold the glove box in place.
3. Remove the two screws.
4. Pull the glove box out from the dashboard.
Once the glove box is removed, you will be able to see the blower motor resistor. It is a small, black box with a few wires connected to it.
To remove the resistor, you will need to:
1. Disconnect the wires from the resistor.
2. Remove the two screws that hold the resistor in place.
3. Pull the resistor out from the housing.
To install the new resistor, simply:
1. Reverse the steps above.
Here is a diagram of the blower motor resistor location:
[Image of the blower motor resistor location]
