The thermostat is located on the engine block, near the top. It is connected to the radiator hose and the water pump.
Tools Needed
- Phillips-head screwdriver
- Flat-head screwdriver
- New thermostat and gasket
- Drain pan
- 5-gallon bucket
- Funnel
- Coolant
Procedure
1. Park your car on a level surface and turn off the engine. Allow the engine to cool down completely.
2. Open the hood of your car.
3. Locate the thermostat housing. It is usually a round or oval-shaped housing located on the front of the engine block, near the top.
4. Place a drain pan under the thermostat housing.
5. Use a Phillips-head screwdriver to loosen the bolts or screws that hold the thermostat housing in place.
6. Once the bolts or screws are loose, carefully remove the thermostat housing. Be careful not to spill any coolant.
7. Remove the old thermostat and gasket from the thermostat housing.
8. Inspect the thermostat for any damage or wear. If the thermostat is damaged or worn, it will need to be replaced.
9. Install the new thermostat and gasket in the thermostat housing. Make sure that the new thermostat is installed in the correct orientation. The side of the thermostat that has a small hole should be facing up.
10. Replace the thermostat housing and tighten the bolts or screws that hold it in place.
11. Refill the cooling system with coolant. Use a funnel to add the coolant slowly.
12. Start the engine and let it run for a few minutes. Check for any leaks from the thermostat housing. If there are no leaks, turn off the engine and top off the coolant if necessary.
