Auto >> AutoSPT >  >> Engine

What 2003 Jeep Wrangler oil?

The recommended oil for a 2003 Jeep Wrangler depends on the engine. You must check your owner's manual for the specific recommendation. However, generally speaking, for a 2003 Jeep Wrangler with a:

* 4.0L inline-6 engine: The recommendation was typically SAE 5W-30. However, using a 10W-30 in warmer climates was also sometimes acceptable.

* 2.4L 4-cylinder engine: This likely also called for SAE 5W-30. Again, consult your owner's manual.

Crucially: The owner's manual will specify the *type* of oil (conventional, synthetic blend, or full synthetic) as well as the viscosity (like 5W-30). Using the incorrect oil can damage your engine. Always refer to your owner's manual before changing your oil.

Auto Repair
How to Replace a GM Ignition Module How do you replace the master power window switch on drivers door of a 1999 subaru outback?
Car Care
A Starter’s Guide on How to Replace Sway Bar Bushings and End Links Where can you get Mercedes trucks on euro truck simulator? Best Factory Installed Audio Systems in 2022
Engine
Where is the temp sending unit on Ford Ranger 2.3L engine? Why would jeep wrangler run hot w new radiator and water pump thermostat?
Electric Car
What is your opinion of the transmission in a 2000 Chrysler Town and Country van? Coolant type for a 2003 Chevy Silverado? How do you recharge air condition on a 1996 Chevy lumina?
Autopilot
When backing up in a motor vehicle why is it important to look behind you and use your rear view mirrors? How do you adjust the tracking on a Peugeot 206?
Car Photos
What is the gross vehicle weight of 2007 Chevrolet Suburban? How are mirrors used in cars? How do you replace a tail light in Jeep Liberty?