- Ratchet set
- Socket set
- Extension
- Screwdriver
- Pliers
- New crankshaft sensor
Instructions:
1. Disconnect the negative battery terminal.
2. Locate the crankshaft sensor. It is usually located near the bottom of the engine, near the flywheel.
3. Use the ratchet and socket set to remove the bolts that hold the crankshaft sensor in place.
4. Use the screwdriver and pliers to disconnect the electrical connector from the crankshaft sensor.
5. Remove the old crankshaft sensor from the engine.
6. Install the new crankshaft sensor into the engine.
7. Hand-tighten the bolts that hold the crankshaft sensor in place.
8. Use the ratchet and socket set to tighten the bolts until they are snug.
9. Reconnect the electrical connector to the crankshaft sensor.
10. Reconnect the negative battery terminal.
11. Start the engine and check for leaks.
