Tools You'll Need:
- Jack and jack stands
- Wheel chocks
- Socket wrench set
- Torque wrench
- Flat-head screwdriver
- C-clamp or brake caliper spreader
- Brake cleaner
- New brake discs and brake pads (if needed)
Instructions:
1. Park your vehicle on a level surface and apply the parking brake.
2. Loosen the lug nuts on the front wheels but don't remove them completely.
3. Jack up the front of the vehicle and secure it with jack stands. Please make sure the car is stable before crawling underneath.
4. Remove the lug nuts and take off the front wheels.
5. Locate the brake caliper on the front wheel hub. It is usually held in place by two bolts.
6. Use a socket wrench to remove the bolts and carefully slide the caliper off the brake disc. Don't let it hang by the brake line, support the caliper with a piece of wire or cable tie to avoid damage.
7. Use a flat head screwdriver to pry open the brake caliper piston. Be gentle, as too much force can damage the piston or seal.
8. Inspect the brake pads for wear and replace them if necessary.
9. Clean the brake disc and hub thoroughly with brake cleaner.
10. Slide the new brake disc onto the hub.
11. Reinstall the brake caliper and secure it with the bolts you removed earlier.
12. Pump the brake pedal several times to seat the caliper piston and firm up the brake pedal.
13. Reinstall the wheels and lug nuts. Tighten the lug nuts in a star pattern and lower the vehicle.
14. Test the brakes by applying them gently while driving slowly.
Remember, brake repairs are critical to your vehicle's safety, so if you're unsure about performing this procedure, it's best to consult with a professional mechanic.
