- New oil filter (OEM part number 11410-21B00)
- New oil (SAE 10W-40, API SG or higher, JASO MA)
- Oil drain pan
- Funnel
- Wrench
- Rags
- Gloves
NOTE: It is recommended that you perform this procedure when the engine is warm, as the oil will drain more easily.
1. Prepare the bike.
- Turn off the engine and let it cool slightly.
- Place the bike on a level surface.
- Position the oil drain pan under the engine, directly below the oil drain plug.
- Remove the oil drain plug using a wrench.
- Allow the oil to drain completely into the pan.
2. Replace the oil filter.
- Locate the oil filter on the right side of the engine, near the top.
- Remove the oil filter using a wrench.
- Apply a thin coat of new oil to the gasket of the new oil filter.
- Screw the new oil filter into place until it is snug.
- Do not overtighten the oil filter.
3. Replace the oil drain plug.
- Once the oil has drained completely, replace the oil drain plug.
- Tighten the oil drain plug securely.
4. Add new oil.
- Use a funnel to add new oil to the engine.
- Refer to the owner's manual for the recommended oil capacity.
- Check the oil level using the dipstick.
- The oil level should be between the "full" and "add" marks on the dipstick.
5. Start the engine and let it run for a few minutes.
- This will circulate the new oil throughout the engine.
6. Recheck the oil level and adjust as necessary.
- The oil level should be between the "full" and "add" marks on the dipstick.
7. Dispose of the old oil and filter properly.
- Old oil and filters are considered hazardous waste and should be disposed of in accordance with local regulations.
