Auto >> AutoSPT >  >> Engine

How do i get citroen dispatch spare wheel back in?

Here's how to put the spare wheel back on your Citroen Dispatch:

1. Prepare your vehicle:

- Park your car on a stable and level surface.

- Turn off the engine and engage the parking brake.

- Release the lug nuts on the flat tire, but don't remove them completely (loosen them about one-quarter turn).

2. Jack up your vehicle:

- Position the jack under the appropriate jack point, which can usually be found on the underside of the vehicle. Please refer to your vehicle's owner manual for the exact location.

- Slowly jack the vehicle up until the flat tire is about 6 inches off the ground (15 cm).

3. Remove the flat tire:

- Remove the lug nuts and place them in a safe place.

- Gently pull the flat tire straight toward you to remove it from the wheel hub.

4. Install the spare tire:

- Place the spare tire on the wheel hub, aligning the lug nut holes with the holes on the spare tire.

- Hand-tighten the lug nuts to secure the tire temporarily.

5. Lower the vehicle:

- Slowly lower the vehicle using the jack until it's just touching the ground.

6. Tighten the lug nuts:

- Using a lug wrench, tighten the lug nuts in a star pattern to ensure even tightening.

- Tighten the lug nuts with all your strength until they are snug.

7. Lower the jack:

- Lower the jack until it is removed from under the vehicle.

8. Double-check the lug nuts:

- Double-check the tightness of the lug nuts. They should be snug but not over-tightened.

- Drive cautiously and at a reduced speed until you can get the flat tire repaired or replaced.

Note:

- If the spare wheel is different from the other wheels on your vehicle, make sure to mount it on the rear axle for improved stability and handling.

- Also, some Citroen Dispatch models may require additional steps, so it's always best to refer to your vehicle's owner manual for the specific instructions for your particular model.