* Terminal 1: Spark plug wire for cylinder 1
* Terminal 3: Spark plug wire for cylinder 3
* Terminal 7: Spark plug wire for cylinder 7
* Terminal 2: Spark plug wire for cylinder 2
* Terminal 6: Spark plug wire for cylinder 6
* Terminal 5: Spark plug wire for cylinder 5
* Terminal 4: Spark plug wire for cylinder 4
* Terminal 8: Spark plug wire for cylinder 8
The distributor cap also has a small metal terminal called the "coil terminal". This terminal is connected to the positive terminal of the ignition coil.
The "setting" for the distributor refers to the position of the rotor button inside the distributor cap. The rotor button should be positioned so that it is pointing towards the terminal for cylinder 1 when the engine is at top dead center (TDC) on the compression stroke.
Here are some additional tips for installing the plug wires on a 351 Windsor engine:
* Make sure that the plug wires are properly seated in the terminals on the distributor cap and the spark plugs.
* Use high-quality plug wires that are rated for the proper voltage.
* Avoid routing the plug wires too close to the exhaust manifolds or other hot components.
* If you are using a spark plug wire loom, make sure that it is properly secured so that it does not come into contact with the exhaust manifolds or other hot components.
