1. Park your car in a safe location and turn off the engine. Pull over to the side of the road or park in a well-lit area. Turn off the engine and engage the parking brake.
2. Locate the brake light assembly. The brake light assembly is usually located in the rear of the vehicle, near the tail lights. It may be necessary to open the trunk or hatchback to access the assembly.
3. Remove the old bulb. Once you have located the brake light assembly, remove the old bulb by turning it counterclockwise. Be careful not to drop the bulb.
4. Insert the new bulb. Take the new bulb and insert it into the socket by turning it clockwise. Make sure the bulb is seated properly.
5. Test the brake light. Turn on the headlights and press the brake pedal. The new brake light should illuminate.
6. Replace the brake light assembly. Once the new bulb is installed, replace the brake light assembly by sliding it back into place.
7. Close the trunk or hatchback. If you had to open the trunk or hatchback to access the brake light assembly, close it now.
Here are some additional tips for changing a brake light bulb:
* If the brake light bulb is difficult to reach, you may need to use a flashlight to see it.
* If the bulb is stuck, you may need to gently pry it out with a screwdriver.
* Be careful not to touch the new bulb with your fingers, as the oil from your skin can cause the bulb to burn out prematurely.
* If you have any doubts about how to change the brake light bulb, consult your vehicle's owner's manual.
