Auto >> AutoSPT >  >> Engine

How do you put transmission fluid in a 1993 Chrysler New yorker?

To add transmission fluid to a 1993 Chrysler New Yorker, follow these steps:

1. Park your car on level ground and turn off the engine. Allow the engine to cool down.

2. Open the hood of your car and locate the transmission fluid dipstick. It is usually marked with a red handle and is located near the back of the engine compartment.

3. Pull the dipstick out of the transmission and wipe it clean with a rag.

4. Reinsert the dipstick into the transmission until it is fully seated.

5. Pull the dipstick out again and check the fluid level. The fluid should be between the "Full" and "Add" marks on the dipstick.

6. If the fluid level is low, add enough transmission fluid to bring it up to the "Full" mark. Be sure to use the type of transmission fluid recommended in your owner's manual.

7. Replace the dipstick and close the hood of your car.