1. Gather your tools. You will need a 14mm wrench, a flathead screwdriver, a drain pan, and some brake fluid.
2. Disconnect the hydraulic line. Use the 14mm wrench to loosen the brake line fitting on the slave cylinder. Be careful not to spill any brake fluid.
3. Remove the bolts holding the slave cylinder in place. There are two bolts that hold the slave cylinder in place. Use the 14mm wrench to loosen the bolts, and then remove them.
4. Pull the slave cylinder out of the bell housing. Once the bolts are removed, you can pull the slave cylinder out of the bell housing. Be careful not to drop the piston out of the slave cylinder.
5. Inspect the slave cylinder. Once the slave cylinder is removed, inspect it for any damage. If the slave cylinder is damaged, it will need to be replaced.
6. Reinstall the slave cylinder. If the slave cylinder is in good condition, you can reinstall it by following the steps in reverse order.
IMPORTANT: Be sure to bleed the brake system after disconnecting the slave cylinder to ensure correct operation.
