1. Park your vehicle on a level surface and let it run for a few minutes to warm up the oil.
2. Turn off the engine and let it sit for a few minutes to allow the oil to settle back into the transaxle.
3. Open the hood of your vehicle and locate the transaxle oil level check plug. It's usually located on the side of the transaxle near the bottom.
4. Remove the oil level check plug, being careful not to spill any oil.
5. If the oil level is low, you can add more through the oil fill plug, which is usually located on the top of the transaxle.
6. Once you've added enough oil, replace the check plug and the fill plug and start the engine.
7. Let the engine run for a few minutes, then turn it off and let it sit for a few minutes.
8. Check the oil level again and make sure it's at the proper level.
NOTE: It's important to check the transaxle oil level regularly and add oil as needed to keep the transmission functioning properly.
