1. Remove the engine from the car.
2. Disassemble the engine by removing the head, cylinders, pistons, and crankshaft.
3. Clean all of the parts thoroughly.
Step 2: Inspection
1. Inspect all of the parts for wear and damage.
2. Replace any parts that are worn or damaged.
Step 3: Reassembly
1. Reassemble the engine by following the steps in reverse order of disassembly.
2. Use a torque wrench to tighten all of the bolts to the correct specification.
Step 4: Installation
1. Install the engine in the car.
2. Connect all of the hoses and wires.
Step 5: Start the Engine
1. Turn the key to the "On" position and wait for the fuel pump to run.
2. Turn the key to the "Start" position.
3. If the engine does not start immediately, pump the gas pedal a few times.
Step 6: Break-In
1. Drive the car for the first few miles at a slow speed.
2. Gradually increase the speed of the car as you get comfortable driving it.
3. Avoid driving the car at full throttle for the first few hundred miles.
Step 7: Enjoy Your Restored VW Bug!
