Auto >> AutoSPT >  >> Car Photos

How do you remove the rear speakers in a 1996 Chevy Monte Carlo. I see them through trunk but it seems they need to be accessed from back seat. get them?

You're right, the rear speakers in a 1996 Chevy Monte Carlo are typically accessed from the rear seat area, not directly through the trunk. There's no easy, universal answer as the exact process might vary slightly depending on trim level and optional equipment. However, the general procedure is as follows:

1. Prepare the area:

* Remove the rear seat: This is usually done by lifting up on the seat bottom cushions. There may be clips or release levers underneath the cushions. Check your owner's manual for specifics on your model. Once the bottom cushions are up, you may find retaining clips or screws securing the backrests; remove those as well.

* Protect the interior: Lay down some towels or blankets to protect the interior from scratches.

2. Locate the speakers:

* With the rear seat removed, you should be able to see the rear deck panel (the panel behind the rear seat). The speakers are usually mounted in this panel.

3. Access and remove the speakers:

* Inspect the Speaker Mounting: Look closely around the speaker. You'll likely find screws holding the speaker to the deck panel. These are often small Phillips head screws. Sometimes, the speakers are held in by clips. Carefully examine the speaker's edge and the surrounding panel for these clips.

* Remove the screws or carefully release clips: Once you've identified how the speaker is secured, carefully remove the screws or release the clips. Work slowly and gently to avoid breaking any plastic clips.

* Disconnect the wiring: After removing the screws or clips, you'll need to disconnect the wiring harness connected to the back of the speaker. This is usually done by gently pulling apart the connector. Make a note of how the connector goes together, as you will need to reconnect it later.

4. Re-installation (in reverse):

Remember to reverse these steps to reinstall your new speakers.

Important Considerations:

* Owner's Manual: Your owner's manual is the best resource for specific instructions on removing interior components. It will provide diagrams and details specific to your vehicle.

* Patience: This can be a bit fiddly, so be patient and take your time.

* Tools: You'll likely only need a small Phillips head screwdriver.

* Pictures: Before you start disconnecting anything, take pictures. This will be invaluable when reassembling.

* Professional Help: If you're uncomfortable with this procedure, consider taking your Monte Carlo to a car audio professional. They have the experience and tools to remove and install the speakers without damaging your vehicle.

Remember safety first! If you are uncertain about any step, seek professional help. Damaging your interior panel can be costly to repair.