Auto >> AutoSPT >  >> Car Photos

How do you remove a pulley lock bolt on 92 Mazda mx-3 if need to see picture i got couple. there are from my phone so not the best but u can parts nice and clear.?

Tools Needed:

* 17mm socket wrench

* Breaker bar

* Extensions

Instructions:

1. Locate the pulley lock bolt on the front of the engine. It is usually located near the crankshaft pulley.

2. Insert the 17mm socket wrench into the bolt and turn it counterclockwise to loosen it. The bolt may be tight, so you may need to use a breaker bar and extensions to loosen it.

3. Once the bolt is loosened, remove it completely.

4. The pulley lock bolt is now removed.

Auto Repair
Can you turn off a check engine light without going to the dealer on 1999 VW Jetta? Is Paintless Dent Repair Right for You?
Car Care
Will Insurance Pay to Fix Your Broken Windshield? How to increase visibility in rain while driving What is the towing capacity for a Nissan Quest?
Engine
Where is the drain tube for air conditioning in a Mazda miata? How do you replace the spark plugs on a 1998 Chevrolet Cavalier Z24 2.4l engine?
Electric Car
Where are the motor bikes on Counterfeit Island? How do you put the spark plug wires back in correct order on a 1994 Toyota 4Runner? Do 2007 ford f350 have auxiliary input?
Autopilot
How much does an Antares auto tune typically cost? How does the relative motion of a motorcycle affect frequency sound heard by an observer on sidewak?
Car Photos
Is a 1999 Jeep Wrangler windshield the same as 2004 windshield? How do you fold rear seat in maruti wagon R? What is the difference between a v6 car and v4 car?