Obtain a replacement brake light: Purchase a replacement brake light assembly that is specifically designed for your Peugeot 308 SW. Make sure it matches the side of the vehicle where you need to replace the brake light.
Locate the brake light assembly: The brake light assembly is located in the rear of your vehicle, typically on the outer edge of the trunk lid or on the side of the vehicle, depending on the model. It is usually held in place by screws or clips.
Remove the old brake light assembly: Once you have located the brake light assembly, use a screwdriver or suitable tool to remove the screws or release the clips that hold it in place. Carefully disconnect the electrical connector at the back of the assembly to detach it.
Install the new brake light assembly: Position the new brake light assembly in place, aligning it with the mounting holes or clips. Fasten it securely by tightening the screws or pushing the clips back into place.
Reconnect the electrical connector: Reconnect the electrical connector to the new brake light assembly to restore power to the brake lights.
Test the brake lights: Once the new brake light assembly is installed, test it by pressing the brake pedal. The brake lights should illuminate properly.
NOTE: If the brake light does not work after replacing the assembly, check the electrical connection to make sure it is secure. You may also need to replace the brake light bulb if it is burned out. If the issue persists, consult your vehicle's owner's manual or seek assistance from a professional mechanic.
