Auto >> AutoSPT >  >> Car Photos

How do you remove the stock stereo in a 1988 Toyota Camry?

To remove the stock stereo in a 1988 Toyota Camry, you will need the following tools:

- A Phillips head screwdriver

- A flat head screwdriver

- A trim removal tool (optional)

Instructions:

1. Turn off the engine and disconnect the negative terminal of the battery.

2. Remove the two screws that hold the center console in place.

3. Pry up the center console with the flat head screwdriver and remove it.

4. Locate the four screws that hold the stereo in place.

5. Remove the four screws and pull the stereo out of the dash.

6. Disconnect the wiring harness from the back of the stereo.

7. Remove the stereo from the vehicle.

To install a new stereo, simply reverse the removal process. Be sure to connect the wiring harness to the new stereo before installing it in the dash.

Auto Repair
Wipers seem to work when they want on a 1998 Chevy silverado? Motorways and Highways
Car Care
Can you export used cars to Vietnam? Can a landlord take possession of customers vehicles? What vehicles harder to operate than a car?
Engine
Where is the fuel pump located on a 2003 Ford F-250 6.0 diesel? What would cause Oil pressure problems on 1986 ford bronco?
Electric Car
Can you turn the head lights off in a 1999 Chevrolet Silverado truck? Check emission system on a 2005 Ford Freestar Van after the light comes? Where is the low beam headlight relay switch on a 1997 Honda civic lx?
Autopilot
How to set the timing marks on cam and crank? What makes motorbikes fast?
Car Photos
Where else besides KSL can one find classified ads for cars? How do you remove parking light lens for 1995 Jeep Grand Cherokee? What is the Kelly Blue Book value of a BMW 2009?