- New replacement bulb (check the owner’s manual for the correct bulb type).
- Philips head screwdriver.
- Flat head screwdriver.
- Pliers.
Step 1: Park your vehicle in a safe, well-lit area and apply the parking brake. Turn the vehicle’s lights to the “off” position.
---
Step 2: Open the hood.
- For the iload, pull the lever under the dashboard (driver's side) and lift the bonnet from the front. Use the prop rod to secure it.
---
Step 3: Locate the headlight bulb housing.
- It is usually a black or gray plastic cover located behind the headlight assembly. Remove the cover to access the bulb.
---
Step 4: Disconnect the electrical connector from the bulb.
- Squeeze the connector’s tabs to release it. Be careful not to pull on the wires.
---
Step 5: Remove the old bulb.
- This can usually be done by turning the bulb counterclockwise. If the bulb is stuck, you may need to use pliers.
---
Step 6: Install the new bulb.
- Insert the new bulb into the socket and turn it clockwise until it is secure.
---
Step 7: Reconnect the electrical connector to the bulb.
- Make sure the connector is firmly attached.
---
Step 8: Replace the headlight bulb housing cover.
- Snap the cover back into place.
---
Step 9: Test the new headlight bulb.
-Turn the vehicle’s lights to the “on” position and check that the new bulb is working properly.
Step 10: Repeat for the other headlight.
