* New oil filter (Honda part number 15410-395-015)
* New crush washer (Honda part number 94109-14000)
* 3 quarts of 10W-40 motor oil
* Oil drain pan
* Funnel
* Wrench
* Rags
1. Warm up the engine for a few minutes to thin the oil.
2. Turn off the engine and place the oil drain pan under the oil drain plug, which is located on the bottom of the engine.
3. Use the wrench to loosen the oil drain plug and allow the oil to drain into the pan.
4. Replace the oil drain plug and crush washer.
5. Remove the oil filter cover by unscrewing the bolts that hold it in place.
6. Remove the old oil filter and insert the new oil filter.
7. Replace the oil filter cover and bolts.
8. Use the funnel to add 3 quarts of new oil to the engine.
9. Check the oil level using the dipstick and add more oil if necessary.
10. Start the engine and let it run for a few minutes.
11. Check for any leaks and make sure that the oil level is correct.
