Tools you'll likely need:
* Flathead screwdriver: For prying and potentially removing trim pieces.
* Phillips head screwdriver: Potentially for removing screws.
* Torx screwdriver: Depending on the specific model, you might need a Torx screwdriver.
* Panel removal tools (optional but helpful): These plastic tools prevent scratching the trim.
* New power mirror assembly: Make sure to get the correct replacement for your vehicle's side (driver's or passenger's).
* Possibly a wiring diagram: This can be incredibly helpful to ensure correct reconnection.
Steps (General - Always Consult Your Repair Manual):
1. Disconnect the battery: This is crucial for safety to prevent short circuits.
2. Remove the door panel: This is usually the most challenging part. Start by removing any visible screws around the door panel's edges. There might be screws hidden under the armrest or other interior components. Gently pry the panel away using your flathead screwdriver or panel removal tools, working your way around the perimeter. Be careful not to break any clips. The panel is usually held on by clips, and they can be brittle.
3. Locate the power mirror connector: Once the door panel is removed, you should see the power mirror's electrical connector. Carefully unplug it. Take a picture or note the connection points for reassembly.
4. Remove the mirror assembly: There are usually a few screws or bolts holding the mirror assembly to the door. Locate and remove these fasteners. The mirror assembly might be held in place by a few clips as well.
5. Install the new mirror assembly: Carefully reverse the removal process to install the new mirror assembly. Make sure to align it properly. Secure it with the screws or bolts.
6. Reconnect the electrical connector: Plug the electrical connector back into the new mirror assembly, ensuring it is securely fastened.
7. Reinstall the door panel: Carefully align the door panel and push it back into place, making sure all the clips engage. Reattach any screws.
8. Reconnect the battery: Reconnect the battery terminals.
9. Test the new mirror: Test the new mirror's functionality (up/down, left/right) to ensure it is working correctly.
Important Considerations:
* Clip breakage: Door panel clips are fragile. Be very careful when removing and reinstalling the door panel to avoid breaking them. You might need replacement clips.
* Wiring: If the wiring is damaged or you're unsure about the connections, consult a wiring diagram for your specific vehicle. Incorrect wiring can damage the new mirror or even other electrical components.
* Professional help: If you're uncomfortable with any of these steps, it's best to take your car to a qualified mechanic.
Remember, this is a general guideline. The exact steps and tools needed may vary slightly depending on your specific 1993 Chrysler New Yorker. Always refer to a repair manual specific to your vehicle before attempting this repair. A Haynes or Chilton manual would be a good investment.
