* Jack and jack stands: To safely lift the vehicle and support it while you work. Never work under a vehicle supported only by a jack.
* Wheel chocks: To prevent the vehicle from rolling.
* Lug wrench: To remove the wheel.
* Socket wrench and sockets: You'll need the correct size sockets to remove the caliper bolts (likely 14mm or 15mm, but check your vehicle's specifications or a repair manual to be sure) and potentially other fasteners. A ratchet is helpful for easier turning.
* C-clamp or brake caliper compression tool: This is crucial to compress the brake caliper piston to make room for the new, thicker brake pads. A C-clamp is a cheaper option but a dedicated tool is easier and safer to use.
* Wrench or pliers (optional): Some caliper designs might require a wrench or pliers to hold or twist certain components.
* Screwdriver (optional): May be needed to remove retaining clips or pins depending on the caliper design.
* Penetrating oil (optional): Apply this to any rusty or seized bolts beforehand to help loosen them.
* Gloves: To protect your hands from grease and dirt.
* Safety glasses: To protect your eyes from flying debris.
* Repair manual (recommended): A repair manual specific to your 2005 Chrysler Pacifica will show you exactly where everything is located and how to remove it properly. This is especially helpful if you're unfamiliar with brake work.
Important Note: Brake work can be dangerous if done improperly. If you're not comfortable working on your brakes, it's best to take your vehicle to a qualified mechanic. Incorrectly installed brakes can lead to brake failure and serious injury or death.
