Replacing the License Plate Light Bulb(s):
1. Access: Locate the license plate light(s). Usually, there's a small access panel either above or below the license plate. This panel is generally held in place by small screws or clips. Remove these fasteners carefully.
2. Bulb Removal: Once the access panel is removed, you should see the bulb(s). The bulb is likely a wedge-base bulb (like a 194 or 168). Gently twist and pull the bulb out of its socket.
3. Bulb Replacement: Insert the new bulb into the socket, ensuring it's seated correctly. Twist slightly to secure it.
4. Reassembly: Replace the access panel and fasteners.
Replacing the Rear Fog Light Bulb:
This is more involved and location varies slightly depending on the specific trim level. It is crucial to consult your owner's manual for the precise location and instructions. Generally, the rear fog light is located in one of the taillights.
1. Access: You will likely need to access the rear fog light through the back of the taillight assembly. This usually involves:
* Removing the taillight assembly: This often requires removing screws or bolts holding the light assembly in place. Be gentle; these clips can be brittle.
* Disconnecting the electrical connector: Carefully disconnect the electrical connector from the back of the taillight assembly.
2. Bulb Removal: Once the taillight is removed, locate the rear fog light bulb (it may be a larger bulb than the license plate light). Refer to your owner's manual to identify it correctly. It might be held in place with a clip or a twist-lock socket.
3. Bulb Replacement: Install the new bulb, ensuring it's correctly seated.
4. Reassembly: Reconnect the electrical connector, carefully replace the taillight assembly, and secure it with the screws or bolts.
Important Considerations:
* Type of Bulb: Make sure you purchase the correct replacement bulb type. The owner's manual will specify this, or you can look at the old bulb for markings.
* Gloves: Wear gloves to avoid getting grease or fingerprints on the new bulbs.
* Electricity: Disconnect the battery's negative terminal before working on the lights if you're uncomfortable working with electricity. This reduces the risk of short circuits.
Remember, this is a general guide. The specifics can vary slightly between models and years. Always check your owner's manual for detailed, model-specific instructions. If you're not comfortable working on your car yourself, take it to a qualified mechanic.
