Auto >> AutoSPT >  >> Auto Repair

To replace two rocker studs on your 67 Chevy c 10 350 can you the pressed in with screw without removing head?

No, you generally cannot replace pressed-in rocker arm studs on a 1967 Chevy C10 350 small-block without removing the cylinder head. The studs are pressed into the head, and there's not enough room to work with them from the top, especially to properly press the new studs in. Trying to do so would likely damage the head or the studs. Removing the head is the proper and safest method for this repair.
Auto Repair
When replacing a starter on 1991 sundance does anything else need to be replaced? How do you replace the shifter linkage on a 1998 SL2 5 speed?
Car Care
Honda Pilot 100,000 Mile Service – What to Expect Backup Camera Installation Guide Can you register one car in state and another different state?
Engine
What size engine is in a 2004 Jeep Cherokee? Where can you find a camaro 1994 engine diagram?
Electric Car
How do you replace a heater fan switch in 1999 Chevy Suburban? What are the torque specs on lug nuts for a 2010 Hyundai Accent? What year did Chevy trucks start using Allison
Autopilot
How could you ride a motorcycle? How do you make an E300 razor scooter go faster?
Car Photos
What is the drag coefficient of 2013 Land-Rover Range-Rover? What does a picture of car with lights shining on the left side your 2000 Toyota Camry dashboard means when driving? Can you locate a car from early 90s without vin?