1. Disconnect the Battery:
- Ensure the vehicle is parked and the engine is off.
- Open the hood and locate the negative (-) battery terminal.
- Disconnect the negative battery terminal using a wrench.
2. Remove the Steering Wheel:
- Using a screwdriver or a suitable tool, pry off the airbag cover to access the steering wheel bolts.
- Loosen the steering wheel bolts but don't remove them completely.
- Mark the position of the steering wheel with respect to the steering column using a marker or a piece of tape. This will help you correctly align it during reinstallation.
- Remove the steering wheel bolts completely and gently pull the steering wheel towards you to detach it from the steering column.
3. Remove the Steering Column Cowling:
- Under the steering wheel, locate and remove the screws holding the steering column cowling in place.
- Carefully remove the steering column cowling by unclipping any retaining clips.
4. Access the Hazard Light Switch:
- Once the steering column cowling is removed, you will see the hazard light switch located behind it.
5. Disconnect the Hazard Light Switch:
- Locate the electrical connector attached to the back of the hazard light switch.
- Press the release tab on the connector and carefully disconnect it from the switch.
6. Remove the Old Hazard Light Switch:
- Unscrew the mounting screws holding the hazard light switch in place.
- Carefully remove the old hazard light switch from its housing.
7. Install the New Hazard Light Switch:
- Take the new hazard light switch and position it in the housing.
- Secure it using the mounting screws.
8. Reconnect the Electrical Connector:
- Attach the electrical connector back to the hazard light switch.
- Ensure it's securely connected.
9. Reinstall the Steering Column Cowling:
- Carefully place the steering column cowling back into position.
- Secure it using the screws you removed earlier.
10. Reinstall the Steering Wheel:
- Align the steering wheel with the mark you made earlier.
- Insert the steering wheel bolts and hand-tighten them.
- Use a torque wrench to tighten the steering wheel bolts to the manufacturer's specifications.
- Reattach the airbag cover.
11. Reconnect the Battery:
- Reconnect the negative (-) battery terminal to the battery.
12. Test the Hazard Light Switch:
- Turn on the ignition.
- Press the hazard light switch to check if it's functioning correctly.
13. Final Checks:
- Ensure that all the components are securely installed.
- Perform a test drive to ensure that the hazard lights are working as intended.
Remember that the precise steps may vary slightly depending on the model and year of the Peugeot 106, so it's always best to consult the vehicle's repair manual or seek assistance from a qualified mechanic if you're unsure about any step.
