Can you replace a 1996 chevy air bag steering wheel for custom one non airbag?

Yes, it is possible to replace the airbag steering wheel in a 1996 Chevy with a custom one that does not have an airbag. However, it is important to note that this modification can be dangerous and should only be performed by a qualified mechanic.

Here are the general steps involved:

1. Disconnect the battery. This is essential to prevent any electrical accidents while working on the steering wheel.

2. Remove the airbag. The airbag is held in place by several screws. Be careful not to damage the airbag or any of the surrounding components.

3. Remove the steering wheel. The steering wheel is held in place by a nut that is located in the center of the wheel. Once the nut is removed, the steering wheel can be pulled off.

4. Install the custom steering wheel. The custom steering wheel can be installed in the same way that the original steering wheel was removed. Be sure to tighten the nut securely to ensure that the steering wheel is properly secured.

5. Reconnect the battery. Once the custom steering wheel is installed, the battery can be reconnected.

It is important to note that this modification may affect the safety features of the vehicle, such as the deployment of the airbags. Therefore, it is highly recommended to have this work performed by a certified technician.