1. Prepare the Lawn Mower: Park the mower on a level surface, turn off the engine, and engage the parking brake. Disengage the blades and allow them to come to a complete stop before proceeding.
2. Locate the Reverse Safety Switch: The reverse safety switch is usually located near the brake or drive pedals on the mower's foot platform. It is typically a small switch that is engaged when the reverse pedal is depressed.
3. Disconnect the Switch Wire: With the engine still off, disconnect the wire leading from the reverse safety switch. On most Cub Cadet models, this is a simple push-connector wire.
4. Jump the Connection: Use a short wire or a connector to create a direct connection between the two terminals on the switch. This bypasses the switch and allows the mower to start and move in any gear without the need to depress the reverse pedal.
5. Reattach the Seat Safety Switch: In some cases, the reverse safety switch may be directly connected to the seat safety switch. If so, you may need to reattach the seat switch to restore proper operation of the interlock system.
6. Test the Bypass: With the safety switches bypassed, start the engine and test the mower's operation. Ensure that the blades only engage when the operator is sitting in the seat and that the mower does not move in any gear without engaging the pedals.
Remember, bypassing safety switches can compromise the safe operation of your mower. It is strongly advised to consult the owner's manual or contact an authorized service center for guidance before attempting any modifications.
