Auto >> AutoSPT >  >> Auto Repair

How do you replace crank seals in 1988 2 stroke ez go?

To replace the crank seals in a 1988 2-stroke EZ GO, you will need the following tools:

- 10mm socket

- 12mm socket

- 14mm socket

- Phillips head screwdriver

- Flathead screwdriver

- Pliers

- Seal puller

- Seal driver

- New crank seals

Here are the steps on how to replace the crank seals:

1. Remove the spark plug.

2. Remove the recoil starter.

3. Remove the clutch cover.

4. Remove the fan assembly.

Remove the cylinder.

5. Remove the piston.

6. Remove the old crank seals with a seal puller.

7. Install a new crank seal with a seal driver.

8. Repeat steps 7-8 for the other crank seal.

9. Reinstall the piston.

10. Reinstall the cylinder.

11. Reinstall the fan assembly.

12. Reinstall the clutch cover.

13. Reinstall the recoil starter.

14. Reinstall the spark plug.

Auto Repair
How do you get the lower steering wheel cover off over tilt lever on a 2003 Ford Sport Trac? How do you reset the gauge cluster on 1999 dodge neon?
Car Care
Who had the best car insurance rated for teenager drivers? Should I Use Synthetic Motor Oil in My Car? Best first cars for a range of budgets
Engine
What size engine does the 2010 Porsche Cayenne have? How can gas get in the oil of a 2004 bombardier outlander?
Electric Car
Where is the oil pump on a 2002 Ford Taurus? Install More EV Charging Ports Today to Meet Tomorrow’s Demand Where is the starter on an 2003 Chevrolet venture?
Autopilot
Torc® performs autonomous drive during solar eclipse Does the x7 4 stroke pocket bike come with a speedometer?
Car Photos
How do you open the rear hatchback on a 1997 Honda wagon from inside? What is the car? What does it mean if your car is smelling like candles?