Here are the general steps on how to bypass the immobilizer on a Peugeot Speedfight 2:
1. Disconnect the Battery: Start by disconnecting the negative terminal of your vehicle's battery to ensure safety and prevent any electrical damage during the process.
2. Locate the Immobilizer Unit: The immobilizer unit on the Peugeot Speedfight 2 is usually located under the seat or near the ignition switch area. It's a small black box with wires connected to it.
3. Find the Ignition Switch Wires: Look for two wires that connect to the ignition switch. These are typically red and black in color.
4. Connect the Ignition Switch Wires: Using a pair of wire cutters or strippers, carefully strip the ends of the two ignition switch wires. Then, connect these wires directly to each other. This essentially bypasses the immobilizer, allowing the ignition switch to work without the immobilizer's authorization.
5. Test the Connection: Once the wires are connected, try turning on the ignition switch. If the scooter starts without any issues, the immobilizer bypass has been successful.
6. Reconnect the Battery: After testing the bypass, reconnect the negative terminal of the battery to restore power to the scooter.
It's important to note that bypassing the immobilizer may compromise your vehicle's security. This modification may make it easier for unauthorized individuals to start your scooter, so take appropriate measures to ensure your safety and the protection of your vehicle.
