1. Safety Precautions:
- Park the ATV on a level surface, and ensure the engine is turned off and cool.
- Disconnect the battery's negative terminal to prevent any accidental electrical discharge.
2. Remove the Seat:
- Locate the seat release mechanism and unlock the seat.
- Remove the seat by lifting it up and off the ATV.
3. Access the Starter Motor:
- Locate the starter motor on the right side of the engine, near the front wheel.
4. Disconnect the Electrical Connections:
- Disconnect the electrical connectors attached to the starter motor by gently prying them off.
5. Remove the Starter Motor Bolts:
- There will be two bolts holding the starter motor in place.
- Use a wrench to loosen and remove these bolts.
6. Remove the Starter Motor:
- Once the bolts are removed, carefully lift the starter motor out of its housing.
7. Inspect the Starter Motor:
- Inspect the removed starter motor for any signs of damage or excessive wear.
- If necessary, consider replacing the starter motor with a new one.
8. Install the New Starter Motor (if needed):
- If you're installing a new starter motor, reverse the removal steps to secure it in place.
9. Reconnect the Electrical Connections:
- Reattach the electrical connectors that you disconnected earlier.
10. Test the Starter Motor:
- Reconnect the battery's negative terminal.
- Turn the ignition key to the "Start" position to test if the starter motor is functioning correctly.
11. Reinstall the Seat:
- Reposition the seat onto the ATV and engage the seat release mechanism to lock it in place.
12. Perform a Test Ride:
- After replacing the starter motor, take the ATV for a short test ride to ensure that the starter motor is functioning properly and starting the ATV without any issues.
Remember to refer to your Yamaha Kodiak 400 ATV service manual for specific details and instructions related to your model. This guide provides general steps, but the actual process may vary slightly depending on the year and specific model of your ATV.
