1. Park the car on a level surface and engage the parking brake.
2. Chock the wheels to prevent the car from rolling.
3. Locate the brake caliper on the wheel you want to work on.
4. Remove the two bolts that hold the caliper in place.
5. Carefully remove the caliper from the rotor.
6. Remove the old brake pads from the caliper.
7. Clean the caliper and the rotor with a wire brush.
8. Apply a thin layer of brake grease to the back of the new brake pads.
9. Install the new brake pads in the caliper.
10. Reinstall the caliper and tighten the bolts.
11. Repeat steps 4-10 on the other wheel.
12. Test the brakes by pumping the brake pedal a few times.
Additional Tips:
* Make sure to use the correct brake pads for your car.
* If you are replacing the front brake pads, you may need to remove the wheel bearing hub assembly to access the brake caliper.
* Be careful not to get brake fluid on your skin or in your eyes. Brake fluid is corrosive.
* If you are uncomfortable performing this task, you can take your car to a mechanic.
