* Replacement driver’s side mirror (available at most auto parts stores)
* Phillips head screwdriver
* Flat head screwdriver
* Torx T30 screwdriver
Instructions
1. Open the driver's door.
2. Locate the three hex head screws on the mirror. These screws are usually located on the bottom of the mirror, inside the car.
3. Use a flathead screw driver to remove the three screws. Set the screws aside.
4. Use a Torx T30 screw driver to remove the two screws on the top of the mirror. Set these screws aside.
5. Gently pry the mirror off of the door. Be careful not to drop the mirror.
6. Disconnect the electrical connector from the mirror.
7. Install the new mirror. Reverse the order of steps 2-7 to install the new mirror.
8. Test the mirror to make sure it is working properly.
