Park the vehicle on a level surface and engage the parking brake.
Loosen the lug nuts on the wheel that you will be working on.
Raise the vehicle with a jack and place a jack stand under the frame.
Remove the lug nuts and take off the wheel.
Step 2: Remove the brake caliper
Remove the two bolts that hold the brake caliper in place.
Gently pry the brake caliper off of the rotor.
Hang the brake caliper out of the way with a piece of wire.
Step 3: Remove the hub assembly
Remove the four bolts that hold the hub assembly to the knuckle.
Gently pry the hub assembly off of the knuckle.
Step 4: Remove the wheel bearing
Remove the snap ring that holds the wheel bearing in place.
Use a bearing puller to remove the wheel bearing from the hub assembly.
Step 5: Inspect the wheel bearing
Inspect the wheel bearing for any signs of damage or wear.
If the wheel bearing is damaged or worn, replace it.
Step 6: Install the new wheel bearing
Press the new wheel bearing into the hub assembly.
Make sure that the bearing is seated properly.
Step 7: Install the snap ring
Install the snap ring that holds the wheel bearing in place.
Step 8: Install the hub assembly
Gently pry the hub assembly onto the knuckle.
Install the four bolts that hold the hub assembly in place.
Step 9: Install the brake caliper
Install the brake caliper onto the rotor.
Install the two bolts that hold the brake caliper in place.
Step 10: Install the wheel
Place the wheel on the hub assembly.
Install the lug nuts and tighten them in a star pattern.
Lower the vehicle and remove the jack stand.
Step 11: Test the brakes
Pump the brake pedal several times to make sure that the brakes are working properly.
Step 12: Road test the vehicle
Take the vehicle for a road test to make sure that the wheel bearing is functioning properly.
