Auto >> AutoSPT >  >> Auto Repair

How to Turn on four wheel drive for a 1988 manual lock in hub Bronco?

To properly engage four-wheel drive in a 1988 manual lock in hub Bronco ensure the vehicle is parked on a level surface and the transmission is in neutral. Follow these steps:

1. Shift the transfer case: Locate the transfer case lever inside the vehicle, typically near the gear shifter. Move the lever from the "2WD" or "RWD" position to the "4WD" position.

2. Exit: Turn off the engine and exit the vehicle.

3. Lock the hubs: Go to the front of the vehicle and identify the wheel hubs on each side. Look for the hub locks or locking mechanisms, which may be located on the hubcap or near the wheel. Rotate these locks to the "LOCK" or "ENGAGE" position.

4. Re-enter: Get back into the vehicle.

5. Start: Start the engine and shift into any forward gear. The four-wheel drive system is now engaged.

Note: Make sure to disengage four-wheel drive when no longer needed, usually done in reverse order of the steps above.

Auto Repair
What Causes of backfiring on a 2006 kawasaki brute force 650 if the battery is removed and replaced? What would make the diagnostic plug not work on a 2000 ford ranger?
Car Care
How much is car insurance for a teen? What is a Fuel Injection Service? Common Causes of Car Air Conditioner Problems
Engine
What would cause Oil pressure problems on 1986 ford bronco? Fully floating axle explain why this is used on heavy commercial vehicles?
Electric Car
89 Buick park Avenue hard start when cold? Where is the fuel pump in a Chevy trilblazer? What is the cooling system capacity of a 1996 Chevy K1500?
Autopilot
Driverless Cars: What they Are and What they Are Not How do I get weapons and characters on Pivot Stick Figure Animator?
Car Photos
What are the dimensions of factory front door speakers in a 1997 Honda Civic DX Sedan 6.5 or 5.25? What is the drag coefficient of 2004 Toyota Corolla? How do you stop a car if sliding on loose gravel down hill?