Auto >> AutoSPT >  >> Auto Repair

2006 Buick lucerne door panel removal?

To remove the door panel on a 2006 Buick Lucerne, follow these steps:

1. Open the door and locate the two screws in the door handle. Remove these screws with a Phillips head screwdriver.

2. Remove the door handle by pulling it straight out.

3. Locate the four plastic caps on the door panel. Pry these caps off with a flat head screwdriver or pry tool.

4. Remove the four screws behind the caps with a Phillips head screwdriver.

5. Locate the two screws at the bottom of the door panel. Remove these screws with a Phillips head screwdriver.

6. Carefully pry the door panel up until the clips release.

7. Disconnect the electrical connectors behind the door panel.

8. Remove the door panel by pulling it straight out.

Auto Repair
What Does A Bad Starter Sound Like? How wheel alignment affects your Mercedes
Car Care
Why Is It So Hard to Shift Into First Gear Unless at A Dead Stop? How to Rotate Your Car Tires How to Pull a J-Turn
Engine
How do you split the engine case on a 1980 Yamaha 175? How much engine oil does a 2003 Lincoln Navigator require?
Electric Car
Which direction do you install the fuel filter on a 1996 Chevy S-10? Where might one look to find a used 2002 Escalade? Can you tow an automatic car with a bar?
Autopilot
How fast is 70cc on a quad bike? How do you set an armitron wr165 FT watch?
Car Photos
Are 1966 and 1967 Buick Skylark Bumpers interchangeable? Is a Porsche foreign car? What is the rear track of 2012 Audi TT-RS?