2. Loosen the lug nuts but do not remove them.
3. Raise the front of the vehicle with a jack and place jack stands under the frame.
4. Remove the lug nuts and wheel.
5. Remove the brake caliper and hang it out of the way with a piece of wire.
6. Remove the spindle nut and washer.
7. Pull the hub assembly off the spindle.
8. Remove the old bearing from the hub assembly.
9. Clean the hub assembly and spindle.
10. Apply a thin coat of grease to the new bearing.
11. Install the new bearing into the hub assembly.
12. Install the spindle nut and washer.
13. Tighten the spindle nut until it is snug.
14. Install the wheel and lug nuts.
15. Lower the vehicle.
16. Replace the cotter pin and hub cap.
