How do you bypass the transponder on a Jeep Cherokee 2004?

Disclaimer: This method should only be used for legitimate purposes and in accordance with your local laws. Bypassing a transponder without authorization may be illegal in some jurisdictions. Proceed at your own risk and please check with your local laws before attempting this procedure.

- Gather your tools and materials. You will need:

* A screwdriver or other tool to pry open the plastic panel around the ignition switch.

* A bypass module specifically designed for the 2004 Jeep Cherokee.

* A wire stripper/crimper.

* Electrical tape.

- Locate the transponder coil. It is usually located around the ignition switch.

- Pry open the plastic panel around the ignition switch.

- Locate the wires connected to the transponder coil. They are usually white and black.

- Cut the white and black wires to the transponder coil.

- Strip the ends of the white and black wires.

- Connect the bypass module to the white and black wires. The bypass module will usually have instructions on how to do this.

- Wrap the connections with electrical tape to secure them.

- Put the plastic panel back in place.

- Start the engine. The bypass module should allow the engine to start without the need for a key or transponder.