2. Remove the right-side lower instrument panel trim cover.
3. Remove the glove box.
4. Remove the two screws that secure the blower motor to the housing.
5. Disconnect the electrical connector from the blower motor.
6. Remove the blower motor from the housing.
7. Reverse the steps to install the new blower motor.
Here are some additional tips:
* Be careful not to drop any screws into the HVAC system.
* If the blower motor is difficult to remove, you can use a pry bar to gently pry it out of the housing.
* Be sure to connect the electrical connector properly before reinstalling the glove box.